Rockwell Automation 20P PowerFlex DC Drive - Frame C Field Circuit Fuse Replacement - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Field Circuit
Fuse Replacement
What This Kit Includes
•
Two 10x38mm, 25A 600V fuse
•
Two fuse holder caps
What You Need to Do 1. Remove and lock-out all incoming power to the drive.
2. Loosen, but do not remove, the screws that secure the bottom protective
cover to the drive, then slide the cover down and off the drive chassis.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
L1 L2 L3
O
I
STS
PORT
MOD NET A
NET B
=
Tightening torque:
1.5 N-m (13.3 lb.-in.)