Rockwell Automation 20P PowerFlex DC Drive - Frame C Power Supply Filter Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Power Supply
Filter Circuit Board
What This Kit Includes
•
Power Supply Filter circuit board (with plug-in terminal blocks)
•
Four screws
•
Cables for connectors X5, XTM and XUV
•
Cable ties
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
Phillips
®
is a registered trademark of Phillips Screw Company.
What You Need to Do To install the Power Supply Filter board:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective covers
❐ Step 3: Remove the existing Power Supply Filter board
❐ Step 4: Install the new Power Supply Filter board
❐ Step 5: Replace the protective covers and document the change
!
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.