Rockwell Automation 20L PowerFlex 700L Drive Cooling Loop Hose Kit - Manual

Installation Instructions
PowerFlex
®
700L
Drive Cooling Loop Hose Kit
What This Kit Includes
• Two hoses
• Two drive side couplings
• Two heat exchanger side couplings
• Two male 1 inch-to-1 inch elbows 37°
(only included with 20L-GHxx-A2 hose kits)
Tools That You Need • Liquid soap
• Tightening wrench
• Backup wrench
Step 1: Attaching a
Coupling to a Hose A. Lubricate the inside of the hose end with a small amount of liquid soap.
B. Set the coupling down on a solid surface and push the hose onto the
coupling — in one firm push — until the hose end is flush against the
plastic bushing. Stopping before the hose is fully on may make it
difficult to push the hose completely onto the coupling.
Step 2: Connecting an
Elbow to a Pipe Nipple
(only 20L-GHxx-A2 Kits) To use a 13 kW capacity PowerFlex 700L Liquid-to-Liquid Heat Exchanger
(catalog number 20L-LL13K-P75A) with a PowerFlex 700L Frame 3A
drive, the 20L-GHxx-A2 hose kit comes with 1-inch elbows that must be
exchanged for the elbows provided with the heat exchanger.
A. Use a 1-3/8 inch or adjustable wrench to remove the 1 inch-to-3/4 inch
reducers and 3/4 inch elbows already assembled on the heat exchanger at
the "TO DRIVE INLET" and "FROM DRIVE OUTLET" connections.
(There is no need to use a backup wrnech on the pipe nipple.)
Hose End
Attached
Solid Surface Coupling