Rockwell Automation 20-HIM-B1 Bezel Kit - Manual

Instructions
Using the 20-HIM-B1 Bezel Kit
The 20-HIM-B1 bezel kit allows remote HIM (Human Interface Module) or WIM
(Wireless Interface Module) operation and provides an additional remote DPI port
for accessories. The bezel cradle connection is used to mount the NEMA 1 HIM or
NEMA 1 WIM and is designated Port 3. The accessory port on the bottom of the
bezel is for standard DPI peripherals such as 1203-SSS, 1203-USB, or another
handheld HIM, and is designated Port 2 (just like the accessory port on the drive).
The internal connection on the back side of the bezel is used to connect the bezel to
the host drive using a standard DPI cable. The 20-HIM-B1 bezel kit cannot be used
with a 1203-S03 two-way splitter cable, or a 1203-SG2 two-way or 1203-SG4
four-way splitter module.
For the drive to receive its speed reference from:
•
The HIM in the bezel, set parameter 90 - [Speed Ref A Sel] or parameter 93 -
[Speed Ref B Sel] depending on your application requirements to “20” (DPI
Port 3).
•
A remote 20-HIM-C* HIM connected directly into Port 2 on the bottom of the
drive, set parameter 90 - [Speed Ref A Sel] or parameter 93 - [Speed Ref B Sel]
to “19” (DPI Port 2).
No. Connector Port ID Description
➊ Internal Connection — Connects the 20-HIM-B1 bezel to the drive.
➋ Lower DPI Port (1)
(1) The bezel’s lower DPI port is always Port 2 and the cradle connection port is always Port 3.
Port 2 Connects a 1203-SSS or 1203-USB converter to the drive.
➌ Cradle Connection (1) Port 3 Connects a HIM or WIM to the bezel.
➊
➋
➌