Rockwell Automation 20B Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 - Manual (Page 13)

Rockwell Automation Publication 20B-IN028B-EN-P - August 2014 13
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
8. Follow steps
a … c to install the replacement bus bar and resistor assembly
into the drive.
a. Install the set screws and nuts removed in step
7c on page 12 . Tighten
the nuts to 5.65 N•m (50 lb•in).
b. Install the bolts removed in step 7b on page 12 . Tighten the bolts to
23.5 N•m (208 lb•in).
c. Install the bolts removed in step 7a on page 11 . Tighten the bolts to
23.5 N•m (208 lb•in).
Frame 8 Drive Shown