Rockwell Automation 802K DIN 50041 IEC/Large Metal Body Standard Limit Switch - Manual

Installation and Operating Instructions
Bulletin 802K DIN 50041 IEC/Large Metal Body Standard Limit Switch
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.
Specifications
Installation of Allen-Bradley products should be in
accordance with local and/or national codes.
Servicing energized industrial control equipment can be
hazardous if not in accordance to recommended safety
procedures.
AC/DC Designation A600; Q600
AC/DC Utilization Category Alternating current: AC15 (50/60 Hz)
Ue (V): 120 240 500 600
le (A): 6 3 1.4 1.2
Direct current: DC13
Ue (V): 125 250 500 600
le (A): 0.55 0.27 0.13 0.1
Max. Fusing Rate 10 A fast acting
Impulse Voltage (Uimp) 2500V
Enclosure Protection IP66
Pollution Degree 3
Storage/Operating
Temperature
-25…+65 °C (-13…+149 °F)
Direct Opening Action Normally closed only
Conductor Sizes Use copper conductors only
Stranded 0.75…2.5 mm2 (0.02…0.09 in.2)
(18…14 AWG)
Solid 0.75…2.5 mm2 (0.02…0.09in.2)
(18…16 AWG)
IMPORTANT
Typical Wiring Diagrams
4 N.C.
41 31 21 11
42 32 22 12
2 N.O. 2 N.C.
43 33 21 11
44 34 22 12
Same polarity this side of block
1 N.O. 1 N.C.
11 23
12 24
Torque/Mounting
Rotating Operator Heads
When rotating operator heads, follow these steps:
1. Loosen the head mounting screws and remove the operating
head from the switch enclosure.
2. Orient the operator head in one of the four positions offered.
Make sure the loose parts are positioned correctly before
affixing the operator head to the switch enclosure.
3. Tighten the four screws per the recommended torque
specifications above.
Location Torque
Heads 1.2 N•m (0.86 lb•ft)
Covers 1.6 N•m (1.18 lb•ft)
M5 Mounting 2.5…3.0 N•m (1.84…3.21 lb•ft)
Wire Clamp 0.9…1.0 N•m (0.66…0.74 lb•ft)
Lever
Clamp
M5 Hex Screw 1.8 N•m (1.33 lb•ft)
M3/M4 Hex Screw 1.5 N•m (1.11 lb•ft)
Adj. Lever Screw 1.0 N•m (0.74 lb•ft)
Conduit 1.0 N•m (0.74 lb•ft)
Internal operator head components can become dis-
lodged when removing operator heads. Use caution
during removal and assembly.
Check for switch operation with a continuity indicator
before placing product in service.
IMPORTANT
IMPORTANT