Rockwell Automation 160 SSC Remote Keypad User Manual - Manual (Page 17)

Chapter
4
Troubleshooting
How to Clear a Fault
When a fault occurs, the cause must be corrected before the fault can be cleared.
After corrective action has been taken, any of the following actions will clear the
fault.
• Press the Remote Keypad Stop button
• Set P54 - [Clear Fault] to 1.
• Disconnect power to the drive, wait three minutes, reapply power.
• Cycle the input signal at TB3-8 to the drive.
Please consult the 160 SSC™ Variable Speed Drive (Series C) User Manual ,
Publication 0160-5.15, for a complete listing of fault descriptions and possible
problems and corrective actions.
ATTENTION: Only personnel familiar with the drive and
associated machinery should plan or implement the installation, start-
up, and subsequent maintenance of the system. Failure to comply may
result in personal injury and/or equipment damage.
ATTENTION: Ensure that you disconnect line power and wait
three minutes before installing or removing the Ready/Fault
Indicating Panel or Program Keypad Module. Failure to do so could
result in personal injury or death.