Rockwell Automation 20-750-xxxx Network Communication Option Card (for use with PowerFlex 750-Series Drives) - Manual (Page 3)

3
B. Replace the larger T15 Torx head screw with the smaller spare T8 Torx
head mounting screw that was shipped with the PowerFlex
20-750-PBUS Profibus option module.
C. Proceed to step 5.
TIP: To remove the captive T15 Torx head screw, the module must
be removed to back the screw out of the mounting clip.
➎
Tighten both of the option module mounting screws to the pod mounting
bracket to properly ground the module to the drive. Tighten both screws to
the recommended torque shown below.
0.45-0.67 N•m
(4.0-6.0 lb•in)
2 Places