Rockwell Automation 810 5.0: Inverse Time Current Relays - Manual (Page 4)

TO REPLACE THE COIL -
Remove the
dashpot assembly, contact block, in-
sulator, and coil terminations. On steel
panel mounted relays also remove
nameplate and its insulator, and the ter-
minal block. Remove set screw holding
core guide assembly in side of frame and
push core guide assembly down and
out. Remove coil washers and coil.
Reassemble by reversing above proce-
dure. Tighten all fasteners securely.
ORDERING INFORMATION -Your
order
cannot be entered unless the following
information is given: Part number, de-
scription of part, catalog number and
series letter of the relay. This instruction
sheet applies also to the above relays
when used on control apparatus listed
under other Bulletin numbers.
RENEWAL PARTS
Parts indicated with are recommended spare parts.
DASHPOT COMPONENTS ARE AVAILABLE ONLY
IN SERIES B CONSTRUCTION.
TERMINAL HOLD DOWN
OPERATING CO
TERMINAL BLOCK
MOUNTING ASSEMBLY
X-2061 48
SLATE PANEL
(2 Required)
MOUNTING BRACKETS
COIL WASHER (2 Required)
F-3826 (600 Volt Application)
F-3947 (2200 Volt Application)
SLATE PANEL
MOUNTING SCREW ASSEMBLY
(Specify Screw Length)
Z-3126 PEDESTAL ASSEMBLY
(2 Included) X-206752
DASHPOTANO
CORE ASSEMBLY -
40188-800-02
CONTACT BLOCK
Z-11011 (NO Hand Reset)
Z-11012 (NC Hand Reset)
Z-11013 (NO Automatic Reset)
Z-11014 (NC Automatic Reset)
Z-15227 (NC Automatic Reset
with Blowout Magnet)
Z-33833 (NO Hand Reset Bifurcated Contacts)
Z-33831 (NC Hand Reset Bifurcated Contacts)
Z-33834 (NO Automatic Reset Bifurcated Contacts)
Z-33832 (NC Automatic Reset Bifurcated Contacts)
NO - Normally Open
NC - Normally Closed
Contact
(See Above)
INSULATOR
, F-17088
SET SCREW
.
CORE GUIDE ASSEMBLY
X-l 8664
I CORE ASSEMBLY
X-34274
,
COVER
M981
OASHPOTAND
PISTON ASSEMBLY-
40188-800-01
DASHPOT RIB
Milwaukee, Wisconsin 53204
BLUE SILICONE
810-N9B
FLUID
CLEAR SILICONE
810-N9C
FLUID
(Single DASHPOT Supply)