Rockwell Automation 802K Metal Adjustable Lever - Manual (Page 2)

10000253527 Ver 01
May 2012 — Printed in USA.
Torque Specifications
Location Torque
Adjustable lever arm
Allen head 4 mm screw 1.4…1.5 N•m
(12.39…13.39 in•lb)
Collar shaft
Allen head 3 mm screw 2.7…3.7 N•m
(23.9…32.75 in•lb)
40 (1.57)
(2.36)
60
16
(0.62) (3.34)
Max.
85
17.5
( 0.69)
dia.
64 (2.51)
7 (0.27)
172 (6.77) M
ax. Ex
tension
(1.18)
30
43 (1.69)
103 (4.05)
Maintenance
These devices require little maintenance, but routine visual
inspection is recommended to keep foreign debris from
collecting on the exterior actuators and rollers.
Removing the operator head is not recommended as loose
internal components may be lost or improperly re-installed.
Actuation Guidelines
The method of actuation and over travel has significant
influence on the service life of the limit switch. To maximize
the service life, it is recommended to provide an actuator with
a 30° pressure angle and a surface hardness of RC-45 max.
Under no circumstances must the switch be
actuated beyond the mechanical travel specified.
Serious damage to the device and property could
result.
ATTENTION
30° 30°
60° 60° 60°