Rockwell Automation 193-DNCT DeviceNet Configuration Terminal - Manual (Page 6)

6 DeviceNet™ Configuration Terminal
Pressing the Enter key will write the new value to the selected device. When a parameter value is
selected, pressing the ESC key will deselect the parameter value and allow you to move within the
parameter list or group. Pressing the ESC key will delete all changes that you made and revert to the
previous settings.
DeviceNet
TM
Configuration
Terminal Setup
Menus
The 193 DeviceNet Configuration Terminal often refers to itself as a “HIM” (Human Interface Module).
When “This DNet HIM” is chosen from the “Network Who” screen, the following HIM Choices Menu
appears:
The HIM Setup menu allows the user to configure many of the programming terminal features.
1) Press the SEL key to select a
bit to change.The selected bit
name is displayed here
Press the “<” (scroll left) or “>” (scroll right) to
select the next bit
2) Press the Increment (or 0) or Decrement (or 1) key or to toggle the bit value
Displays version information
Allows the user to perform
Faulted Node Recovery for
nodes that fail the Dup Mac
ID test
Displays and latches Network Diagnostic information such as
Baud Rate, Bus Voltages, Bus Loading characteristics and
CAN errors
Displays the HIM Setup Menu
(shown below)
Displays a DeviceNet communication
error log
Invokes the Terminal Setup screen
described above
Sets up the 5 security passwords:
1 primary and 4 secondary
passwords. Primary passwords
enable/disable all editing
functions Secondary passwords
enable/disable editing of the
features presented by the terminal
Auto Display setup enables the
display of up to 4 parameter
values from one of more devices
at powerup
Configures the operation of the User
Keys: F1, F2, F3, F4 and Reset
Adjust the screen contrast