Rockwell Automation 20G PowerFlex 755 IP00 Spare Parts - Manual

Installation Instructions
PowerFlex 755 IP00 Spare Parts Installation Information
ATTENTION: Only qualified personnel familiar with adjustable frequency AC
drives and associated machinery should plan or implement the installation,
start-up, and subsequent maintenance of the system. Failure to comply may
result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the
bus capacitors has discharged completely before servicing. After removing
power to the drive, wait 5 minutes for the bus capacitors to discharge. Measure
the DC bus voltage at the DC+ and DC- TESTPOINT sockets on the front of the
power module. The voltage must be zero.
ATTENTION: HOT surfaces can cause severe burns. After disconnecting power
allow time for cooling.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing, testing,
servicing or repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with static control
procedures, reference Guarding Against Electrostatic Damage, publication
8000-4.5.2 or any other applicable ESD protection handbook.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber optic cable connectors.