Rockwell Automation 598-N5 Enclosure Mounting Pad Foot Kit - Manual

ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Install
in suitable enclosure. Keep free from contaminants.
Enclosure Mounting Pad Foot Kit
56 x 30 Enclosure
(Cat 598-N5)
1
1
2
(2) locations
center holes only
typical each mounting foot
Note: Enclosure needs to be elevated to allow
assembly of mounting pad feet. Use blocks or
a heavy duty table.
(2) locations
typical each side panel of enclosure
(2) locations
typical each mounting foot
2
175-200 lb-in
33.842"
11.00"
9.686"
175-200 lb-in
1 4
ENCLOSURE MOUNTING PAD FOOT KIT
INSTALLATION INSTRUCTION SHEET
1 1005696
42052-079
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
E - DOC
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
B-vertical.ai
DWG.
SIZE
SHEET
B
1 2 3 4 5 6 7 8
A
B
C
D
E
F
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
42052
THIS DRAWING IS THE PROPERTY OF
ROCKWELL INTERNATIONAL CORPORATION
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL INTERNATIONAL CORPORATION
J. Veliquette 1-14-04
1-14-04
1-14-04
M. Jutz
J. Koziczkowski