Rockwell Automation 440P-WC1A Short Lever - Manual (Page 2)

Drwg. No. 10000101182 Ver 00
February 2011
Printed in USA
Mounting Dimensions [mm (in.)]
Torque Specifications
Maintenance
These devices require little maintenance, but routine visual
inspection is recommended to keep foreign debris from
collecting on the exterior actuators and rollers.
Removing the operator head is not recommended as loose
internal components may be lost or improperly re-installed.
Actuation Guidelines
The method of actuation and over travel has significant
influence on the service life of the limit switch. To maximize
the service life, it is recommended to provide an actuator with
a 30° pressure angle and a surface hardness of RC-45 max.
Location Torque
Philips head screw 1.4…1.5 N•m (12.39…13.28 in•lb)
ATTENTION: Under no circumstances must the switch
be actuated beyond the mechanical travel
specified. Serious damage to the device
and property could result.