Rockwell Automation 198E-C0C4R Plastic Encl. for DOL and Rev. Starters with Motor Protection C.B. - Manual (Page 2)

Assembly of Reversing Starters
3 2 1
5
4
Assemble the reversing contactor:
• Turn the coil terminals to the load side according
the contactors instruction sheet.
• Place the mechanical interlock between contactors
• Insert the dovetail connector from rear side
• Attach the reversing connection on load side
• Attach the parallel connection and the Eco
connection module on line side
The enclosure fits for both,
the 140M-C and the 140M-D
MPCB.
For the 140M-D, shorten the
support by breaking off the
2 tabs.
Snap the 800F contact blocks
Prepare the MPCB by replacing the knob and
adding the auxiliary:
• Remove original knob
• Remove front cover
• Add auxiliary and lockable twist knob
onto the device support:
• Pos. 2 (center): N.C. contact
• Pos. 3 (left): N.O. contact
Do the control wiring according
the wiring diagram/wire table.
Snap the reversing contactor
onto the metal hat rail
(2)