Rockwell Automation 1395 Digital DC Drive FRN 5-10.10/9.30 - Manual (Page 237)

Chapter 7
Programming Parameters
7-71
Parameter 841 – SP Indirect 2 [SP Indirect 2]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: When programmed, appears as a constant Source
Parameter value at Parameter 11, and can be linked to a Sink
Parameter.
ATTENTION: For system indirect inputs, proper values, Min/ Max
limits and polarities must be observed. Entering incorrect values,
limits or polarities could cause the drive to operate in a runaway or
erractic condition.
Parameter 842 – SP Indirect 3 [SP Indirect 3]
Internal units : None
Programming Terminal units: None
Minimum Value: – 32767
Maximum Value: + 32767
Default Value: 0
Description: When programmed, appears as a constant Source
Parameter value at Parameter 12 and can be linked to a Sink
Parameter.
ATTENTION: For system indirect inputs, proper values, Min/ Max
limits and polarities must be observed. Entering incorrect values,
limits or polarities could cause the drive to operate in a runaway or
erractic condition.