Rockwell Automation 1326AB, 1394, 842A Absolute Encoder Feedback Adapter Kit - Manual (Page 3)

1326AB Absolute Encoder Feedback Mounting Adapter Kit 3
Publication 1326A-5.29 — February 2000
5. Apply the new endbell gasket on the adapter, position the adapter
assembly onto the back of the motor, and insert the encoder shaft
into the coupling.
6. Attach the adapter to the motor using the screws supplied.
Tighten the screws using no more than 2.3-2.8 N-m (20-25 lb-in.)
of torque.
7. Remove the inspection plugs on the side of the adapter to gain
access to the coupling.
8. Rotate the coupling in relation to the unfastened shaft, allowing
the coupling to seek a normal resting position.
Figure 2
Bringing the Coupling to its Normal Resting Position
9. Tighten the coupling onto the encoder shaft. When tightening, use
no more than 1.8-2.0 N-m (16-18 lb-in.) of torque. The shaft must
be visible through the spacings in the coupling.
10. Replace the inspection plugs.
Important: Ensure that the coupling is not compressed or
stretched after it has reached its normal resting
position.
11. Check for proper operation.
Coupling
Motor Shaft
Encoder Shaft