Rockwell Automation 1494V-DSxx Series D Variable Depth Disconnect Switch - Manual (Page 4)

(4)
Connecting Rod Adjustment Procedure
"ON" Position
Move disconnect handle to the "ON" position.
If switch does not fully close, return handle to "OFF" position.
Remove link spring hitch pin and disengage the connectiong rod from the primary link.
Turn connecting rod counter-clockwise (1 or more) full turns.
Re-engage connecting rod in primary link of handle, insert hitch pin and re-test
Repeat
- as necessary.
Re-install link spring
"OFF" Position
Move disconnect handle to the "OFF" position.
If switch does not fully open, return handle to "ON" position.
Remove hitch pin and link spring, then disengage the connectiong rod from the primary link.
Turn connecting rod clockwise (1 or more) full turns.
Re-engage connecting rod in primary link of handle, insert hitch pin and re-test.
Repeat
- as necessary.
Re-install link spring
1
2
Connecting
Rod
Hitch Pin
Primary Link
Drive Bar
PN-47400
DIR 10000056505 (Version 00)