Action - receptacle control, Stop all action, Voltage sensitivity – Rockwell Automation 1609 UPS Management Software User Manual User Manual
Page 27: Transfer voltage
Rockwell Automation Publication 1609-UM007A-EN-P - January 2013
25
Bulletin 1609 UPS Management Software User Manual
Action - Receptacle Control
Allows you to control the Receptacle Relay on or off. Each Receptacle Relay may
control not only one outlet, please see the rear panel of your UPS or the UPS
hardware user's manual.
Stop All Action
Clicking on this, terminates all the actions immediately.
Voltage Sensitivity
Adjust the UPS voltage sensitivity.
Transfer Voltage
Changes the low transfer voltage and high transfer voltage. This function lets
your UPS adjust to the local power environment.
Low Transfer Voltage: When utility power voltage drops lower than the
assigned value the UPS will switch to backup mode. The output power is
supplied from the battery.
High Transfer Voltage: When utility power voltage rises higher than the
assigned value, the UPS will switch to backup mode. The output power is
supplied from the battery.