Rockwell Automation 1494V-DS30_DSX30_DS60_DSX60_DS100_DSX100 Variable Depth 30A / 60A / 100A Disconnect Switch - Manual (Page 2)

PN-133619
DIR 42052-136 (Version 05)
Copyright © 2013 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.
ATTENTION: Check for proper operation.
Go to Installation Instruction Sheet PN-47400.
Trailer Fuse Block Installation 5
Cutting Connecting Rod
N
Enclosure
Working Depth
(Inside Flange
of Enclosure to
Mounting Plate)
Mounting
Plate
Verify that disconnect switch and handle are in "OFF"
position. (Switch blades will be visible.)
Measure working depth of enclosure.
3
Connecting Rod Installation
4
Measure, mark and
cut connecting rod.
Drive Bar
N minus 3-1/8"
1
1
2 Remove burrs 3
Rotate connecting rod into
drive bar (10) full turns.
Connecting
Rod
Hitch Pin
Primary Link
2
5
6
5
6
Verify if rod is nearly
touching bottom
of bolt head.
(If not, rotate rod up to
5 full turns)
3
4
Enclosure depth
8 in. or less
Enclosure depth
greater than 8 in.
7
8b
8a
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication 1494V-IN099E-EN-E - January 2013