Rockwell Automation 1394 Shunt Modules Fuse Replacement Kit - Manual

Publication 1394-6.6 — March 1999
Installation Instructions
1394 Shunt Modules Fuse Replacement Kit
(Catalog Numbers 1394-SR10, -SR9A, -SR9AF, -SR36A,
and -SR36AF)
This document illustrates replacing the fuse in the 1394 shunt modules
(Catalog Numbers 1394-SR10, -SR9A, -SR9AF, -SR36A, and -SR36AF).
Replacing the 1394-SR10
Fuse
To replace the 1394-SR10 shunt module fuse:
1. Remove power from your system including power to the shunt module.
2. Locate the fuse holder.
Figure 1
Fuse Holder Location
!
ATTENTION: This system may have multiple
sources of power. More than one disconnect switch
may be required to de-energize the system. To avoid
shock hazard or personal injury, verify that all power
has been removed before proceeding.
!
ATTENTION: This product contains stored energy
devices. To avoid hazard of electrical shock, verify that
all voltage on the capacitors has been discharged before
attempting to service, repair, or remove this unit. You
should only attempt the procedures in this document if
you are qualified to do so and familiar with solid-state
control equipment and the safety procedures in
publication NFPA 70E.
To COL
To DC+
Fuse Holder