Rockwell Automation 1397 150HP AC Line Disconnect Inst. - Manual (Page 2)

1397 150HP AC Line Disconnect 2
1397-5.21 July, 1997
GRD
A1 45
P4
P4
P4 S4 S4 S4
181 182 183
Retaining
Screw
Panel
Tab
Panel
Tab
Retaining
Screw
❐ 2 Loosen the (2) auxiliary panel cover retaining screws. To lift out
the auxiliary panel, loosen the screws only enough to allow the
panel tabs to slide out.
❐ 1 Remove and lockout all incoming power to the drive. Disconnect
the incoming power lines from the drive by removing the wire
binding screws on the box connectors at terminals 181, 182
&
183.
Installation
ATTENTION: Electric Shock can cause injury or death.
Remove all power before working on this product.
The drive is at line voltage when connected to incoming AC
power. Before proceeding with any installation or
troubleshooting activity, disconnect lockout and tag all
incoming power to the drive. Verify with a voltmeter than no
voltage exists at terminals L1, L2 and L3 on the drive input
power terminal block.
!