Rockwell Automation 1394 Terminator - Manual

Publication 1394-6.4 November 1998
Installation Instructions
Installing Your 1394 Terminator
This document illustrates the installation of the 1394 terminator and
is used in conjunction with the 1394 Digital AC Multi-Axis Motion
Control System User Manual (publication 1394-5.0).
Installing the 1394 Terminator
To install the 1394 terminator:
1. Verify that power has been removed from your system.
2. Attach the terminator to the right most axis module on your
system and slide the terminator to the left until it locks into place.
Figure 1
Attaching the Terminator
3. Apply power to your system.
!
ATTENTION: This system may have multiple
sources of power. More than one disconnect switch
may be required to de-energize the system. To avoid
shock hazard or personal injury, assure that all power
has been removed before proceeding.
!
ATTENTION: This product contains stored energy
devices. To avoid hazard of electrical shock, verify that
all voltage on the capacitors has been discharged before
attempting to service, repair, or remove this unit. You
should only attempt the procedures in this document if
you are qualified to do so and familiar with solid-state
control equipment and the safety procedures in
publication NFPA 70E.
Terminator 1394 Digital Servo Controller
System Module
Allen-Bradley