Rockwell Automation 1403-DMA_DMB PowerMonitor II Display Module - Manual (Page 3)

Bulletin 1403 Powermonitor II Display Module 3
Publication 1403-5.2 – September 1996
Fiber Optic Cable Assembly Strain Relief A strain relief
feature at the rear of the Display Module and a wire tie
are provided for securing the fiber optic transmit and
receive cable assemblies. Use the strain relief feature to
protect the fiber optic connections at the rear of the
Display Module. Coil each fiber optic cable into an
approximately one inch diameter loop and secure each
loop to the rear of the Display Module with the wire tie
provided per Figures 3, 4, and 5.
Figure 3. Fiber Optics Strain Relief
1. Insert the wire tie into the slot on the Display
Module’s rear cover.
Figure 4. Fiber Optics Strain Relief
2. Push the wire tie into the slot and force it out of the
second, adjacent slot.
Figure 5. Fiber Optics Strain Relief
3. Install and secure both fiber optic cables. The cables
should be coiled into one inch minimum diameter
loops and secured with the wire tie.
Cat. No. Explanation and Accessories See Bulletin 1403
Powermonitor II Instruction Sheet, Publication
1403–5.0, Appendix B for the Display Module Cat. No.
explanation and a listing of all fiber optic accessories.
Additional Information
Refer to these sections of Bulletin 1403 Powermonitor II
Instruction Sheet, Publication 1403–5.0, for additional
information:
•
Chapter 4, General Operation – for configuring the
Master Module using the Display Module
•
Appendix B, Mechanical Dimensions
•
Appendix C, Technical Specifications