Rockwell Automation 1426-COMM-CNT PowerMonitor 5000 Unit Optional Communication Modules User Manual
Page 4
4
Rockwell Automation Publication 1426-IN002A-EN-P - April 2013
PowerMonitor 5000 Unit Optional Communication Modules
5. Gently insert the module into its socket until the module is seated.
6. Tighten the screws with a Torx 8 screwdriver to 0.25 N•m (2.2 lb•in).
7. Check that the module is properly seated.
The rear edge of the module bezel aligns with the front panel of the power
monitor. Tightening the screws engages the fastening cams with holes in
the circuit board, which helps resist efforts to remove the card.
Step 5 Insert module
Step 6 Tighten to
0.25 N•m
(2.2 lb•in)
Step 7 Module bezel
aligns with the
front panel.
Virtual Wiring
Correction
---- S1
S2
---- S3
S4
---- S com
S com
---- K
Y
---- Z
R1 O
---- R1 com
R1 C
---- R2 O
R2 com
---- R2 C
R3 O
---- R3 com
R3 C
Module
status
Network
status
Config Loc
EtherNet
√IP
PowerMonitor 5000
Power
USB
Device
USB
Host
LNK
ACT
I 1
I 2
I 3
I 4
L1
L2
GND
24V
com
Scom
S n
Internal
24 VDC
K
Y
Z
Rx O
Rx com
Rx C
V1
V2
V3
VN
VG
1
DS
NS
23
4
5
Devic
eNet
Tighten to
0.25 N•m (2.2 lb•in)