Rockwell Automation 1336F PLUS II Custom Firmware Inst. - EN916 - Manual (Page 3)

EN916 - Variable Voltage Control 3
Voltage Control
[Volt Trim% Ref]
This parameter specifies the voltage command trim% val-
ue added/subtracted to [Volt Preset] when [Volt Select] is
set to “Pre+TrimRef”. The trim value is
±
Volt Trim% of
[Rated Voltage].
Minimum Input = –Volt Trim% Value
Mid-Point Input = No Trim
Maximum Input = +Volt Trim% Value
The parameter value is cleared at power-up and is not
retained in eeprom storage. This parameter is intended to
be used with a SCANport communications adapter via the
[Data In xx] Adapter I/O parameters.
Parameter Number 341
Parameter Type Read and Write
Display Units / Drive Units 1% / 4096 = 100%
Factory Default 0%
Minimum Value 0%
Maximum Value +100%