Rockwell Automation MV SMC Flex OEM Components - Interface Board - Manual

MV SMC Flex OEM Components
Interface Board – Instruction Sheet
A T T E N T I O N A T T E N T I O N Do not touch or bend the connectors on the
Interface Board when handling it. Damage to the
connectors may result in loss of communication
signals from the MV SMC Flex to other
components.
Carefully unpack the item and inspect it for damage that may have
occurred during shipping. Immediately report any damage to the
claims office of the carrier. Rockwell Automation will render
reasonable assistance in resolving a damage claim.
A T T E N T I O N A T T E N T I O N Electrical components may be damaged or
destroyed by electrostatic charges that build up in
personnel during normal activities. To avoid
damage to the equipment, observe the following
precautions.
To guard against electrostatic damage (ESD) to equipment the
following precautions should be observed when handling
electrostatic sensitive devices.
1) Use a grounding wrist strap to minimize the build up of static
charge on personnel.
2) Handle the module by the edges and avoid touching
components or printed circuit paths.
3) Store devices with sensitive components in the conductive
packaging that the module is shipped in.
These precautions are the minimum requirements for guarding
against ESD. For more information refer to Guarding Against
Electrostatic Damage - Publication 8000-4.5.2.
Handling
Interface Board Interface Board