Rockwell Automation 1771-ID16GM Installation Instructions - Manual

Publication 1771-IN001A–EN–P – May 2000
ac (120V) Isolated Input
Module
Cat. No. 1771-ID16GM
Use this document as a guide when installing the ac Isolated Input
module.
For information on: See Page:
General Information 2
Understand compliance to European Union directives 2
Calculate power requirements 2
Initial handling 3
Set the filter time 3
Key the backplane connector 5
Install the module and field wiring arm 5
Connect the wiring to the module 6
Interpret the status indicators 8
CSA Hazardous Location Approval 10
Specifications 11
!
ATTENTION: The 1771-ID16GM isolated input
module is designed specifically for General Motors
Corporation use only. This module has specific input
current requirements as outlined in the specifications at
the end of this installation instruction.
For proper circuit operation:
• maximum input voltage is limited to 120V ac
• all inductive or solenoid input loads must provide
external surge suppression
In addition, this module has been qualified for Bulletin
700P style 120V relay circuits only.
Use this module in a series B or later I/O chassis. The
1771-ID16GM is not compatible with the 1771-AL
local I/O adapter.
Installation Instructions
Contents