Install the ni-fbus configuration software – Rockwell Automation 1788-CN2FF Foundation Fieldbus Configuration Tool Software User Manual
Page 2
2 1788-FFCT Foundation Fieldbus Configuration Tool Software
Publication 1788-IN057A-EN-P - March 2004
Install the NI-FBUS Configuration Software
Follow these instructions to install the configuration software:
1.
Insert the CD-ROM into a drive on your computer.
2.
Select Start => Run.
3.
Browse the CD-ROM drive and select the file Setup.exe.
4.
Click OK.
5.
At the Welcome to the NI-FBUS Configurator (SP) Installation Wizard window, read
the recommendations and click Next.
6.
At the License Agreement window, click the radio button to accept the license
agreement and click Next.
7.
At the User Information window, fill in appropriate information and click Next.
8.
At the Destination Folder Window, choose the default installation location or click
Browse
to choose an alternative.
9.
When finished, click Next.
10.
At the Select Board Type window, leave item checked at the default and click Next.
11.
At the Ready to Install the Application window, click Next unless you wish to reenter
information or exit the wizard.
Please wait while the setup program is installing and updating your system.
The Interface dialog box appears.
It is not necessary to make any configuration
changes at this time, you can do it later from
the software.
12.
Click Cancel.