Rockwell Automation 1768-ENBT CompactLogix EtherNet/IP Communication Module Installation Instructions - Manual (Page 15)

CompactLogix EtherNet/IP Communication Module 15
Rockwell Automation Publication 1768-IN002B-EN-P - August 2010
Wire the Module
Use an RJ45 connector to connect to the EtherNet/IP network.
Connect the Module
IMPORTANT We recommend connecting the module to the network via a
100 MB Ethernet switch, which will reduce collisions and lost
packets and increase network bandwidth. For detailed
EtherNet/IP connection information, see the EtherNet/IP
Modules in Logix5000 Control Systems User Manual,
publication
ENET-UM001 .
WARNING: If you connect or disconnect the cable with power
applied to this module or any device on the network, an electrical
arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
8
1
8 ------ NC
7 ------ NC
6 ------ RD-
5 ------ NC
4 ------ NC
3 ------ RD+
2 ------ TD-
1 ------ TD+