Rockwell Automation 1757-FIMRTP ProcessLogix Remote Termination Panel (RTP) Installation Instructions User Manual
Page 8
Advertising
8 ProcessLogix Remote Termination Panel (RTP)
Publication 1757-IN915A-EN-P - October 2001
Connecting the RTP to the FIM
This procedure assumes that the 1757-FIM is installed. Use the following procedure
to connect the RTP cable to the FIM:
1. Turn off the power supply in the chassis.
2. Plug one end of the RTP cable into the connector on the RTP (labeled J1 on
3. Plug the other end of the cable into the connector on the FIM, through the
cutout in the door.
4. Turn on the power supply.
WARNING
!
When you connect or disconnect any wiring to the FIM with
power applied, an electrical arc can occur. This could cause an
explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
Advertising