Bissell PowerWash Deluxe 1694 series - Manual (Page 10)

10
Pre-Treating (Optional)
Set the ReadyTools Dial to TOOLS/PRETREAT.
Plug the PowerWash Deluxe into a proper outlet
and turn ON the Power switch.
While pressing the Spray Release trigger, slowly
make several passes over the area to be cleaned.
Caution: Do not overwet.
Turn the machine Power Switch OFF and let
BISSELL Fibre Cleansing Formula dissolve the
tough soil for 1 to 2 minutes. Reset the ReadyTools
Dial to FLOOR CLEANING before continuing.
1.
2.
3.
Improves cleaning effectiveness for heavily soiled
carpet in high traffic areas, such as entryways
and hallways.
4.
Normal Cleaning
Plug the PowerWash Deluxe into a proper outlet
and turn ON the Power Switch.
While pressing the Spray Release trigger, make
one slow forward and back wet pass. Let the
BISSELL Fibre Cleansing Formula and DirtLifter
Power Brush* do the work for you.
*On select models
Caution: Do not overwet.
Release the trigger and make one slow forward
and back pass over the same area to remove any
residual dirty water.
Repeat cleaning passes without pressing the
trigger until you can’t see any more water being
suctioned up.
When cleaning job is complete, refer to the
Maintenance/Storage section on page 14.
1.
2.
3.
4.
5.
Tip:
Thorough
vacuuming before
deep cleaning will
prevent early
clogging of the
lint trap.