Rockwell Automation 1756-ENET/B ControlLogix Ethernet Communication Interface Module User Manual - Manual (Page 25)

1 Publication 1756-UM051B-EN-P - November 2000
Chapter
2
Installing the Ethernet Module
What This Chapter Contains This chapter describes how to install the module in the ControlLogix
chassis and connect it to the network. The following table describes
what this chapter contains and where to find specific information.
Identifying Module
Features Use the following illustration to identify the external features of the
1756-ENET/B module.
For information about See page
Insertion and Removal Under Power 2-2
Installing the Ethernet Module 2-2
Preparing the Chassis for Module Installation 2-2
Determining Module Slot Location 2-3
Inserting the Module in the Chassis 2-4
Removing or Replacing the Module (when applicable) 2-5
Wiring the Ethernet Connector 2-6
Connecting the Module to the Ethernet Network 2-6
Applying Chassis Power 2-7
Checking Power Supply and Module Status 2-8
< www > ETHERNET
OK TXD RXD
AUI
10 BASET
1756-ENET
Backplane
Connector Product
Label
AUI Ethernet
Connector
10BT Ethernet
Connector
Side View Front View
Front
Panel
MAC ID
Label