Rockwell Automation 1753-PCS-USB RSLogix Guard PLUS Programming Software - Manual (Page 2)

2 RSLogix Guard PLUS! Programming Software
Publication 1753-IN006C-EN-P - November 2005
Uninstall RSLogix Guard PLUS! Software
1. From the Windows Control Panel, choose Add/Remove Programs.
2. If you want to uninstall version 3.5, select RSLogix Guard PLUS! Hardware
Management. If you want to uninstall version 4.0 or later, select RSLogix
Guard PLUS! version x.x.x.x.
3. Click on Change/Remove.
4. Choose OK when asked whether to remove the program and all of its
components.
5. Close the Add/Remove Programs dialog and the Control Panel, if necessary.
6. If you uninstalled version 4.0 or later, the unistall process is complete. If you
are uninstalling version 3.5, continue with the additional steps below.
a. Start the RSLogix Guard PLUS! Control Center and choose Uninstall.
b. Open/Run the program from the File Download dialog.
It may take up to a minute for the next prompt to appear.
c. Choose Yes when prompted whether you want to proceed with the
uninstall.
d. If the message dialog does not automatically appear, check the task bar,
maximize the dialog, and choose Yes.
e. Choose Yes when prompted if you would like to complete the next step
of the uninstall procedure, which removes the registration entries for the
software.