Rockwell Automation 1791-IOBB USER MANUAL - Manual (Page 25)

Chapter
4
4Ć1
Configuring Your Block I/O for SLC
Controllers
In this chapter you will learn how to configure your block I/O when used
with SLC family controllers. This includes the following:
setting the configuration switches
addressing the block I/O
Refer to publication 1747–NM004 Series A, “Distributed I/O Scanner,“
and publication 1747–NM005 Series A, “RIO Scanner” for complete
information on switch settings and addressing of the block I/O.
Each block I/O module has two 6–position DIP switches for setting:
block address
transmission (baud) rate
last state or reset
DH–485 termination
These switches are accessible by opening the door on the left side of the
module (Figure 4.1).
Chapter Objectives
Setting the Configuration
Switches