Rockwell Automation 1771-OW16/B Electro Mechanical Relay Contact Output Module - Manual

1 Publication 1771-IN069B-EN-P - November 2005
Installation Instructions
Electromechanical Relay Contact Output
Module
Cat. No. 1771-OW16 Series B
Inside…
Important User Information
To: See Page:
Important User Information 1
Preinstallation Considerations 5
Calculate Power Requirements 6
Key the Backplane Connector 7
Install the Module and Field Wiring Arm 7
Connect Wiring to the Field Wiring Arm 8
Interpret the Status Indicators 11
Specifications 12
Rockwell Automation Support BackCover
Solid state equipment has operational characteristics differing from those of
electromechanical equipment. Safety Guidelines for the Application,
Installation and Maintenance of Solid State Controls (Publication SGI-1.1
available from your local Rockwell Automation sales office or online at
http://www.rockwellautomation.com/literature) describes some important
differences between solid state equipment and hard-wired electromechanical
devices. Because of this difference, and also because of the wide variety of
uses for solid state equipment, all persons responsible for applying this
equipment must satisfy themselves that each intended application of this
equipment is acceptable.
In no event will Rockwell Automation, Inc. be responsible or liable for
indirect or consequential damages resulting from the use or application of
this equipment.
The examples and diagrams in this manual are included solely for illustrative
purposes. Because of the many variables and requirements associated with
any particular installation, Rockwell Automation, Inc. cannot assume
responsibility or liability for actual use based on the examples and diagrams.
No patent liability is assumed by Rockwell Automation, Inc. with respect to
use of information, circuits, equipment, or software described in this manual.
Reproduction of the contents of this manual, in whole or in part, without
written permission of Rockwell Automation, Inc., is prohibited.