Rockwell Automation 1771-ICD DC(20-60V)Input Module Installation Instructions - Manual

Installation Instructions
Publication 1771-5.29 – February 2000
DC (20Ć60V) Input Module
Cat. No. 1771ĆICD Series B
This document provides information on:
•
important pre-installation considerations
•
power supply requirements
•
initial handling procedures
•
installing the module
•
using the indicators for troubleshooting
•
module specifications
The 1771-ICD series B module must be used in a series B 1771 I/O
chassis (1771-A1B through -A4B) or a 1771-AM or -AM1 chassis.
Make sure no other input module or single card block transfer
module is placed in the same module group when using 2-slot
addressing. Any discrete output module may be used within the same
module group.
European Union Directive Compliance
If this product is installed within the European Union or EEA
regions and has the CE mark, the following regulations apply.
EMC Directive
This apparatus is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) using a technical construction
file and the following standards, in whole or in part:
•
EN 50081-2 EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2 EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
The product described in this manual is intended for use in an
industrial environment.
Low Voltage Directive
This apparatus is also designed to meet Council Directive 73/23/EEC
Low Voltage, by applying the safety requirements of EN 61131–2
Programmable Controllers, Part 2 – Equipment Requirements and
Tests.
To The Installer
Pre-installation
Considerations