Rockwell Automation 1738-VHSC24M23 ArmorPoint 24V dc Very High Speed Counter Module, Series A User Manual
Page 6
Publication 1738-IN011B-EN-E - August 2013
6 ArmorPOINT 24V DC Very High Speed Counter Modules, Series A
Install the ArmorPOINT
Very High Speed
Counter Module
To install the ArmorPOINT Very High Speed Counter module, proceed as
follows.
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base
clockwise until the number 2 aligns with the notch in the base.
2. Position the module vertically above the mounting base. The module
will bridge two bases.
3. Push the module down until it engages the latching mechanism. You will
hear a clicking sound when the module is properly engaged.
The locking mechanism will lock the module to the base.
Remove the ArmorPOINT Very High Speed Counter Module From
the Mounting Base
To remove the module from the mounting base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch.
The module will lift up off the base.
3. Pull the module off of the base.
MOD
NET
1738-VHSC24M23/A
24V dc In
A
B
Z
0
1
Module will bridge two bases.
43804