Output wiring – Rockwell Automation 1734D-IB8XOB8 POINT I/O Installation Instructions User Manual
Page 5
POINTBlock dc 8 Input/8 Output Module 5
Publication 1734-IN020A-EN-P - July 2001
Output Wiring
Note: When connecting more than 1 wire in a termination point, make sure
that both wires are the same gauge and type.
Outputs are electronically protected to 0.75A. Module outputs are
selectable for latched mode or auto-reset mode. (Latched/auto reset is set
by module, not by individual channel.) Each channel is assigned a bit in the
data table to indicate the faulted condition. Outputs in the latched mode can
only be reset with a user command to the module.
Output Terminal
Common Terminal
Power
Remote Termination Block 3
Channel 0
0
4
Channel 1
1
5
Channel 2
2
6
Channel 3
3
7
Remote Termination Block 4
Channel 4
0
4
Channel 5
1
5
Channel 6
2
6
Channel 7
3
7
Module power is supplied from the internal power bus.
Out 0 Out 1
Out 3
Out 2
C
C
C
C
Load
Load
42015
Load
Load
V = 12/24V dc, C = Common
Field power is supplied from internal power bus
0
2
6
3
1
7
4
5
RTB3 shown