Rockwell Automation Logix5000 Controllers Function Block Diagram Programming Manual - Manual (Page 29)

Program a Function Block Diagram Chapter 1
2. Wire the ICON to the input pin.
3. Double-click the operand area of the ICON.
4. In the box, click the down arrow and click the name of the OCON that
supplies the value to this connector.
5. Click Enter or click a blank spot on the diagram.
Rename a wire connector
Edit the name of an input wire connector or an output wire connector in a
routine.
1. Right-click the operand area of the desired ICON or OCON, and click
Rename Element.
2. In the box, type or select a new name and press Enter.
Rename a connector group
Wire connectors that share the same connector name can be changed in a routine.
Tip: If there are wire connectors with the new name, the renamed wire connectors merge with the existing
connectors.
1. Right-click the operand area of the desired ICON or OCON, and click
Rename Connector Group.
2. In the box, type or select the new name and press Enter.
All instances in the group are changed to the new name.
Rockwell Automation Publication 1756-PM009E-EN-P - October 2014 29