Rockwell Automation 1769-SM1 Compact I/O-to-DPI/SCANport Network Communication Module - Manual (Page 7)

7
Step 8 Apply power.
A. Apply power to the controller. The status indicators can be viewed on
the front of the 1769-SM1 module after power has been applied.
B. The module is assigned a unique network address by the bus master
during initialization.
C. Apply power to the drive. When you apply power to the 1769-SM1
module, controller, and network for the first time, the status indicators
should be green after an initialization. If the status indicators go red,
there is a problem. Refer to the “Troubleshooting” chapter in the
1769-SM1 Compact I/O to DPI/SCANport Module User Manual.
Step 9 Read the 1769-SM1 Compact I/O to DPI/SCANport Module User Manual
for information to configure and determine how to apply the network to the
host product(s).
!
ATTENTION: Risk of equipment damage, injury, or death
exists. Unpredictable operation may occur if you fail to verify
that parameter settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.