Rockwell Automation 1746-HSCE High-Speed Counter Module Installation Instructions - Manual (Page 11)

High-Speed Counter Module 11
Publication 1746-IN011C-EN-P - April 2005
Remove the Terminal Block
The removable terminal wiring block eliminates the need to rewire a module if it is
removed from the chassis. Each terminal accepts two #14 AWG wires.
Remove the terminal block by turning the slotted terminal block release screws
counterclockwise. The screws are attached to the terminal block, so it will follow as
the screws are turned out.
Wire the Removable Terminal Block
Use a flat or cross slot screwdriver to tighten terminal screws. Each screw should be
turned tight enough to immobilize the wire’s end. Overtightening can strip the
terminal screw. Do not exceed 0.7 to 0.9 Nm (6 to 8 in-lbs.).
ATTENTION
Disconnect power before attempting to install, remove, or wire
the removable terminal wiring block.
To avoid cracking the removable terminal block, alternate the
removal of the slotted terminal block release screws.