Rockwell Automation 1738-IB16DM12 ArmorPoint 24V DC 16 Point Input and Output Modules - Manual (Page 6)

6 ArmorPoint 24V DC 16 Point Input and Output Modules, Series A
Publication 1738-IN023B-EN-E - February 2010
Install the mounting base as follows:
1. Lay out the required points as shown above in the drilling dimension
drawing.
2. Drill the necessary holes for M4 (#8) machine or self-tapping screws.
3. Mount the base using M4 (#8) screws.
4. Ground the system using the ground lug connection.
The ground lug connection is also a mounting hole.
Mounting Base
ATTENTION
To comply with the CE Low Voltage Directive (LVD), this equipment must be
powered from a source compliant with the following:
Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).
Keyswitch
Set to position 1 for the
1738 24V expansion
power supply
Ground lug connection
Latching mechanism
43675