Rockwell Automation 2100 Connecting a CENTERLINE Motor Control Center DeviceNet Unit to a DeviceNet MCC - Manual (Page 4)

Publication 2100-IN048C-EN-P—February 2003
4 Connecting a CENTERLINE® Motor Control Center (MCC) DeviceNet Unit to a DeviceNet MCC
Adding and Removing Columns) and choose the new location from the
drop-down list.
After the above selections are completed 'click' the Apply button to save the
change in the software.
Moving IntelliCENTER units to a different MCC lineup
After moving an IntelliCENTER unit to a different lineup (physically moving
the unit from one IntelliCENTER MCC to another) the unit location must be
reflected in the IntelliCENTER software. This is done by entered into the
Spreadsheet View of the IntelliCENTER in which the unit was moved from.
Open the Spreadsheet View by selecting Spreadsheet - from the View menu or
by 'clicking' on the Spreadsheet View icon.
In the Spreadsheet view 'right click' in the Spreadsheet View and select Move
Unit to Another Lineup from the Edit menu.