Rockwell Automation 2094 LIM Remove/Replace Internal Components - Manual (Page 14)

Publication 2094-IN009C-EN-P — April 2008
14 Removing and Replacing the Line Interface Module Internal Components
2. Determine your ease of access to the cooling fan.
3. Remove the four phillips screws that hold the finger guard and
fan in place.
4. Set the finger guard aside.
5. Pull the fan away from the LIM module and disconnect the
power cord.
6. Go to Replace the Cooling Fan on page 15 .
If access to the fan is Then
Limited (insufficient clearance to access
fan screws) Remove the LIM module from the cabinet (1)
before proceeding to step 3 .
(1) For drive system component removal/replacement procedures, refer to the appropriate servo-drive
user manual in Additional Resources on
page 21 .
Not limited (adequate clearance to
access fan screws)
Go to step 3 .
2094-BL02
Line Interface Module
2094-BL02
Line Interface Module