Brocade Communications Systems ServerIron ADX 12.4.00 - Manual (Page 181)

ServerIron ADX Global Server Load Balancing Guide 169
53-1002437-01
Displaying GSLB information
1
The GSLB protocol allows you to query the site ServerIron ADXs for configuration information as
well as the session and CPU information used by the GSLB policy. You can view detailed
configuration information and statistics for the site ServerIron ADX, from the GSLB management
console. You can display the following information:
• Real server configuration
• Virtual server configuration
• Port binding information (for the bindings between TCP/UDP ports on the real servers and the
virtual server that represents the real servers)
• Session statistics for sessions between clients and the real servers
To display real server information for the real servers configured on a remote ServerIron ADX, enter
commands such as the following at any level of the GSLB ServerIron ADX’s CLI.
ServerIronADX(config)# rshow 209.157.22.209 server real

Real Servers Info
Name : rs1 Mac-addr: abcd.5a11.d042

IP:10.10.10.1 Range:1 State:Active Wt:1 Max-conn:1000000
Port State Ms CurConn TotConn Rx-pkts Tx-pkts Rx-octet Tx-octet Reas

---- ----- -- ------- ------- ------- ------- -------- -------- ----

ftp enabled 0 0 0 0 0 0 0 0

http enabled 0 0 0 0 0 0 0 0

default unbnd 0 0 0 0 0 0 0 0

Server Total 0 0 0 0 0 0 0
Name : rs2 Mac-addr: abcd.5a11.d043

IP:10.10.10.2 Range:1 State:Active Wt:1 Max-conn:1000000
Port State Ms CurConn TotConn Rx-pkts Tx-pkts Rx-octet Tx-octet Reas

---- ----- -- ------- ------- ------- ------- -------- -------- ----

ftp enabled 0 0 0 0 0 0 0 0

http enabled 0 0 0 0 0 0 0 0

default unbnd 0 0 0 0 0 0 0 0

Server Total 0 0 0 0 0 0 0

The command in this example displays real server configuration information for the remote
ServerIron ADX with management IP address 209.157.22.209. As shown in
Figure 1 on page 4,
this ServerIron ADX is part of the “sunnyvale” site and is configured to load balance two real
servers. In this example, the real servers are named rs1 and rs2.
Syntax: rshow <remote-ip-addr> server real | virtual | session | bind
The <remote-ip-addr> parameter specifies the remote ServerIron ADX’s management IP address.
The real | virtual | session | bind parameter specifies the information you want to display:
• real: displays real server information. This option is equivalent to entering the show server real
command on the remote ServerIron ADX.
• virtual: displays virtual server information. This option is equivalent to entering the show server
virtual-name-or-ip command on the remote ServerIron ADX.
• session: displays session statistics. This option is equivalent to entering the show server
session command on the remote ServerIron ADX.
• bind: displays port binding information. This option is equivalent to entering the show server
bind command on the remote ServerIron ADX.