Rockwell Automation 2364, 2364F Regenerative DC Bus Supply Unit (RGU) Upgrade Kit - Manual (Page 8)

8 Regenerative DC Bus Supply Unit (RGU) Upgrade Kit
13. Place the cover and standoffs for the cover onto the new isolator board.
See Figure 8. The new wire harness has a new connector for the LEM
that was added in Step 1 - Adding The Third LEM. It may also need the
short harness to supply 120Vac to the power supply.
Figure 8
Step 3. Installing the
Power Supply
Filter Board and
Bracket Assembly
1. Carefully unpack the power supply filter board (P/N 192424) and
bracket (P/N 192418) assembly. Using the two (2) screws provided,
attach the bracket of this assembly to the new door assembly. See
Figure 9 below.
2. Remove the four (4) screws that hold the clear lexan cover (P/N
192425) on the filter board assembly. Remove the lexan cover in order
to access the two terminal blocks. See Figure 9 below.
Figure 9
New isolator board
mounted to door
1. Attach filter board
bracket to the new door
assembly
2. Remove clear Lexan
cover