Rockwell Automation 2364 Control Fuse Replacement User Manual
Page 3
Advertising
Bulletin 2364 Control Fuse Replacement
3
Publication 2364-5.12 - April 1998
Removing a Control Fuse
Use this procedure to remove the fuse:
1. Remove all Lexan guards that shield the fuse.
2. Use a suitable tool to pull the fuse out of fuseblock.
Figure 1
Rejection-Type Fuses in Fuseblock
Installing a Control Fuse
Use this procedure to install the fuse:
1. Verify that the fuse is of the correct size and type.
2. Use the "fuse-puller" tool to press the fuse into place.
Note: Rejection type fuses can only be installed one way.
3. Install any Lexan guards that were removed.
4. Dispose of the removed part according to your company’s proce-
dures and local ordinances.
Advertising