Rockwell Automation 2711-NF5 Function Key Legend Kit for PanelView 1400 Terminals - Manual (Page 3)

Function Key Legend Kit 3
Installing the Insert
1. Turn off power to PanelView Terminal.
!
ATTENTION: Disconnect power whenever working on the back
panel side on the PanelView Terminal. Failure to disconnect
power may result electrical shock and/or damage to the terminal.
2. Remove any power or communications cables that block the insert slot.
3. Locate the legend insert slots.
4. Remove any tape that holds the legend insert tab.
5. Pull on tab and remove old insert.
6. Slide the new insert into the slot (as far as it will go) so that the printed side
will face the front of the terminal.
Side Legend Strip
Bottom Legend Strip
7. Check the front of the terminal to verify that the inserts properly
identify the function keys.
8. A new strip of tape may be required to secure the legend insert tabs to the
terminal side.