Rockwell Automation 2711P-RFKx Function Key Legend Kit - Manual (Page 7)

Function Key Legend Insert Kit 7
Publication 2711P-IN023C-EN-P - March 2007
Replace the Function Key Legend Inserts in Terminal
To replace the F1-F10 function key insert on the PanelView Plus 600 terminal:
1. Remove power from the terminal.
2. From the rear of the unit, pull the old legend strip out from the slot on the
lower side of terminal.
3. Slide the new legend insert into the same slots with the key legends facing
the front of the display.
The very end of the insert will be visible.
To replace the function key legend inserts (F1-Fxx and K1-Kxx) on the PanelView
Plus 700 to 1500, and PanelView Plus CE terminals, you must first remove the
display module bezel.
1. Remove power from the terminal.
2. Remove the display module bezel as described in the PanelView Plus and
PanelView Plus CE user manual, publication 2711P-UM001.
3. Pull out the old legend inserts from the slots on the bezel.
4. Insert the new legend inserts into the same slots until the end tab is visible.
5. Replace the display module bezel.
PanelView Plus 600 Terminals